Hello there,

I've been playing around with Contiki 2.1 today and as a result, I wrote a program for the c64 that lets you customize your Contiki network configuration (contiki.cfg), just as Oliver's web tool does . It's simple, absolutely not fool-proof and - the moment - c64 based only. But yet very useful. Enjoy!

UPDATE:
The new program now allows manual selection of the drive # to which the config file will be written (thanks to schema for mentioning that problem). The new file is attached to this posting.

_________________
LOAD ":*",8,1
READY.
RUN

Finally got around to trying this. Thanks! A couple of suggestions though...

• The device# is hardcoded to #8 which could be fixed to use the current drive from $BA. (Mind you, it's haardcoded in Contiki as well [sigh] so it's not that big of an issue.)
• Feel free to use my IP address input routine: http://codebase64.org/doku.php?id=base:ip_address_input
• Echoing back what you entered to confirm before saving would be very handy!

I've added manual selection of the device # and also a confirmation routine before saving. See updated original posting.

_________________
LOAD ":*",8,1
READY.
RUN

Hi,

Just for the sake of completeness I'd like to add that the recently made available Contiki 2.4 binary release for Retrocomputing contains a DHCP client which beside actually using DHCP as well allows to manually edit the IP settings in the Contiki network configuration file (contiki.cfg) using an interactive (mouse-enabled) UI. However there's no possibility to edit the Ethernet driver and Ethernet port settings.

Regards,
Oliver